This “Chip Off the Ol’ Color Block” knit mitten pattern was made with Manos del Uruguay Maxima yarn, a hand-spun and hand-dyed merino wool whose purchase supports rural Uruguayan women. You can substitute any 100% extra-fine yarn in a medium worsted weight, but be sure to check the gauge first. The gauge of the pictured wool is 4.5 to 5 stitches per 1 inch on US 6 and 8 (4 and 5 mm) size needles.
The pair of mittens using this knit mittens pattern will take 4-1/2 to 5 hours to knit. These instructions will produce small or medium-sized mittens. Changes for large and extra-large sizes are noted in parentheses as necessary.
Tools and Materials
- Hanks of #4 medium-weight 100% merino wool yarn in the following colors, each about 3-1/2ounces and 219 yards:
- Medium blue (A)
- Hot pink (B)
- Neon yellow (C)
- Light blue (D)
- Set of US 6 (4 mm) double-pointed needles
- Set of US 8 (5 mm) double-pointed needles
- Blunt-end yarn needle
- 3 stitch markers, one in a contrasting color for the beginning of the round
- Stitch holder
Gauge
In stockinette stitch (aka “stocking stitch”), worked in the round with the larger needles, 18 stitches and 26 rounds = 4 inches, blocked
K2P2 ribbing (multiple of 4 stitches)
Pattern round (RS): *K2, P2; repeat from the * around
Stockinette stitch worked in the round (any number of stitches)
All rounds: Knit around
Left Mitten
Cuff
With smaller double-pointed needles and A yarn (medium blue), cast on 32 (40) stitches. Place a marker for the beginning of the round. Join, being careful not to twist the stitches.
Begin the K2P2 ribbing, and work even until the piece measures approximately 3-1/2 (4) inches from the beginning.
Change to B yarn (hot pink) and the larger needles. Begin stockinette stitch worked in the round, and use the M1, or “Make 1,” technique to increase 2 (0) stitches evenly spaced on the first round — 34 (40) stitches.
Continue even in stockinette stitch worked in the round until the piece measures approximately 4-1/2 (5-1/2) inches from the beginning.
Place additional markers after the first stitch and before the last stitch of the round.
Begin Thumb Gore
Next round (increase round): Knit to first marker, M1 knitwise, slip the marker, work to next marker, slip the marker, M1 knitwise, knit to end of the round — 36 (42) stitches.
Repeat the increase round every other round 3 (5) more times, then every 4 rounds once — 44 (54) stitches including 12 (16) thumb stitches between the markers.
Knit one more round, ending when you reach the second marker.
Separate Thumb from Hand
Remove the marker and slip 12 (16) stitches onto a holder or piece of scrap yarn, and using C yarn (neon yellow), use the e-wrap cast-on technique (pictured at right) to cast on 2 stitches; place a marker for the new beginning of the round. Then, use the e-wrap cast-on technique to cast on 2 more stitches and complete the round — 36 (42) stitches.
Continue even until the piece measures approximately 10 (11-1/2) inches from the beginning, and use the K2tog method to decrease 4 (2) stitches evenly spaced along the last round — 32 (40) stitches remain.
Decrease for Tip
Next round: *K2, K2tog; repeat from the * around — 24 (30) stitches remain.
Work even for 1 (2) rounds.
Next round: *K1, K2tog; repeat from the * around — 16 (20) stitches remain.
Work even for 1 (2) rounds.
Next round: *K2tog; repeat from the * around — 8 (10) stitches remain.
Break the yarn, leaving a 6-inch tail. Thread tail through the remaining stitches and pull it tight to secure. Fasten off.
Thumb
Slip the 12 (16) stitches from the holder onto 2 double-pointed needles.
Use a third double-pointed needle and D yarn (light blue), and pick up and knit 4 stitches along the cast-on at thumb — 16 (20) stitches.
Knit across the first 6 (8) stitches of thumb. This is now the beginning of the round. Place a marker.
Continue even for 1-3/4 (2-1/4) inches above the thumb cast-on stitches, and use the K2tog technique to decrease 1 (2) stitch(es) evenly spaced along the last round — 15 (18) stitches remain.
Next round: *K1, K2tog; repeat from the * around — 10 (12) stitches remain.
Next round: *K2tog; repeat from the * around — 5 (6) stitches remain.
Break yarn, leaving a 6-inch tail. Thread tail through the remaining stitches and pull it tight to secure. Fasten off.
Right Mitten
Follow the same instructions as with the left mitten, but substitute yarn color D for A, C for B, A for C, and B for D.
Finishing
Hide all remaining yarn tails. Block to 8 (9-1/2) inches palm circumference and 11 (12-1/2) inches in length.
Melissa Leapman is an American crochet and knit designer who creates designs for major yarn companies. She’s the author of several bestselling knit and crochet books. This project is excerpted from her latest book, InstaKnits.
Originally published as “Color Block Mitten Pattern” in the September/October 2023 issue of Grit magazine and regularly vetted for accuracy.



